|
 |
 |
|
|
|
|
 |
|
|
 |
It's all
new, awesome, and Soundstream
at its finest! The entire Rubicon
line-up of amplifiers has been
revised from inside out. From
the sleek and stylish new chassis,
to the cleaner, more stable guts,
the new Rubicon amplifiers are
sure to impress all who look and
listen…
On
the inside, many improvements
have been engineered to give a
higher quality listening experience.
The updated circuitry yields lower
distortion (THD) for overall cleaner
output. The gain management stages
have been altered to produce a
higher Signal to Noise Ratio (SNR)
with lower noise floor. While
these are two of the biggest factors
in making high quality amplifiers,
the all new circuitry also raises
the damping factor for better
control, higher input impedance
to avoid overworking your source
unit which reduces noise level
and lowers distortion even further.
All of the new amplifiers are
10%-15% more efficient due the
more intelligent power supply!
This results in less current draw
from your battery and less heat
to dissipate via the heat sink
chassis. Turn-On and Turn-Off
pops are eliminated due proper
sequencing during start-up and
shut-down. The crossover section
is greatly improved for versatility
and maintaining uniform slopes
at all frequencies. The ground-to-audio
ground isolation has also been
improved for less engine noise
problems. Rather than having speakers/subwoofers
damaged by DC, a new protection
circuit will automatically shut
the amplifier down. We also added
a direct input for the 5 th channel
for great control on the 5-channel
model. The monoblock models have
a new remote control that is much
more linear throughout the adjustment
range, rather than from the mid
to max range only. Quite possibly
the greatest improvement on all
models is the higher quality MOSFET
power supply transistors resulting
in improved reliability.
|
|
|

|
•
Infinitely Variable Crossovers
w/ Multipliers (High/Full/Band/Low)
• 35Hz Subsonic Filter (mono
block models)
• 50Hz Bass Boost, 6 or 12dB
• MOSFET PWM Power Supply
• IDI™ Intelligent
Distress Indicator for Thermal,
Short, & Impedance Protection
• Turn On/Off Delay
• 180º Phase Switch
(mono block & 5 ch. models)
• Tri-Mode Capable
• 2/4/5 Channel Input
• 2 Ohm Stereo / 4 Ohm Mono
Stable (2 ch. & 4 ch. models)
• 2 Ohm Mono Stable (mono
block models)
• High & Low Level Input
• Platinum 4 AWG Power Block |
|
|
|